Galvanized locking nuts for turnbuckles can be purchased from marine supply (
not sailboat!) wholesalers, typically supplied in pairs (a left hand and a
right hand nut). It can be difficult to purchase small quantities from
wholesale suppliers if you're not a regular customer.
Someone recommended McMaster-Carr; however, their left hand threaded nuts are
plated and will not fit over galvanized turnbuckle threads.
My recommendation is that you stick with the standard practice in the T O W E
R industry: use a safety wire in a figure 8 configuration. Turnbuckle
locknuts are not a generally accepted solution in the tower industry.
---- Original message ----
>Date: Fri, 01 Dec 2006 08:19:11 -0800
>From: Bill Turner <email@example.com>
>Subject: Re: [TowerTalk] Locking a Turnbuckle...??
>To: "Tom Osborne" <firstname.lastname@example.org>
>On Thu, 30 Nov 2006 21:28:15 -0800, "Tom Osborne" <email@example.com>
>>There are lock nuts and bolts that have holes in the end of the bolt for a
>>cotter pin or some other type of pin to go through. Kinda like the nut on
>>your wheel bearings. 73
>------------ REPLY FOLLOWS ------------
>Ok, but same question I posed earlier: One of the nuts has a reverse
>thread. Where do you get such a nut?
>I suspect that threading the guy wire through the turnbuckle is the
>easiest and best method.
>TowerTalk mailing list
TowerTalk mailing list