It was Ez-Way that started it now Aluma uses it, its a 6" dia pipe, 6' goes in
the ground and 8' is
above ground the tower pivots across the top to fold over There are two sets of
fins one at the
bottom of the pipe and one just below the 6' level. The fins are 3" at 90º. The
secret is to dig a
hole 12" in dia. I used a Bobcat with a 12" post hole digger and a 3ft
extension. I took the better
part of a week to back fill. a little at a time with some water and a lot of
tamping. It supports a
75HD crank up and a 4 element SteppIR for 5 years with out any problems.
[mailto:email@example.com] On Behalf Of
Sent: Sunday, December 03, 2006 6:36 PM
Subject: Re: [TowerTalk] TowerTalk Digest, Vol 48, Issue 12
Could be a Wonder Bar. Looks like a torpedo. Several sizes, from 8 to 10 feet
long, very heavy
I believe EZWay Towers manufactored the WB out of Tampa Florida.
The WB sticks out of the ground about 6 feet with a hinge on top. The WB does
not need cement or
Hope this helps...
John Bescher, n4dxi
TowerTalk mailing list