| To: | jim@walkersdomain.com, towertalk@contesting.com |
|---|---|
| Subject: | Re: [TowerTalk] [SPAM] Re: Cutting 3/16" EHS... |
| From: | SavageBR@aol.com |
| Date: | Sun, 3 Dec 2006 12:06:40 EST |
| List-post: | <mailto:towertalk@contesting.com> |
If you only have a dozen or so cuts to make (one tower's worth), use a 1 inch cutoff wheel on a Dremmel tool. It will give you a clean cut with no barbs or sharp edges. Buy a package of the wheels it may take more than one. Bruce _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Rust on Tower Cable, Fred_W . _Hurd |
|---|---|
| Next by Date: | Re: [TowerTalk] cutting 3/16 EHS, Kimo Chun |
| Previous by Thread: | Re: [TowerTalk] TowerTalk Digest, Vol 48, Issue 12, n4dxi |
| Next by Thread: | Re: [TowerTalk] cutting 3/16 EHS, Kimo Chun |
| Indexes: | [Date] [Thread] [Top] [All Lists] |