Used to have a Ham IV - sold it and bought the
Yaesu G-1000. I'm very happy with that
decision. I've had the Yaesu for about 7 years,
and had no problems. Used it when I lived in
Alaska, and it survived 100 mph plus wind gusts,
turning a Mosley Pro57B40 and a Cushcraft 5L 6M
beam. It now turns my SteppIR 4L, and the wind
gusts here in CO have hit 88 mph. Combined with
the IdiomPress rotor controller card, it's a
wonderful piece of equipment. YMMV....
At 03:40 AM 12/8/2006, JMLTINC@aol.com wrote:
>I am writing for a friend who is not Internet enabled.
>He has been a Ham IV user since it's introduction. As a moicrowaver, his
>towers see a good load. He keeps a spare rotor
>to swap out when one in service
>fails, which is often.
>He is now considering replacing these (as they fail again) with Yaesu
>You opinions between these two rotors (only these please) is greatly
TowerTalk mailing list