[Top] [All Lists]

Re: [TowerTalk] height fold over kits?

To: "'richard allen'" <>, <>
Subject: Re: [TowerTalk] height fold over kits?
From: "k6xyz" <>
Date: Sat, 9 Dec 2006 09:14:30 -0600
List-post: <>
I would get the US tower.
If you do, you can drive to their Kansas location and pick it up yourself.
This will save a lot of time and money and probably easier to get service
Call this guy for more info.

Ken Millman, K1ZKM
Amateur/Commercial Division
Direct Line: (530) 333-0440
Direct Fax:  (530) 333-0390
US Tower Corporation
1099 West ropes Avenue
Woodlake, CA  93286
Phone: (559) 564-6000
Fax:   (559) 564-6011


Dave Harmon
Sperry, Ok.

-----Original Message-----
[] On Behalf Of richard allen
Sent: Saturday, December 09, 2006 8:29 AM
Subject: [TowerTalk] height fold over kits?

I am trying to decide between a us tower hdx555 with the motor drive 
and foldover fixture and/or  a heights foldover aluminum tower of 
equivalent height.

Either will have a 10-20 foot mast at the top with one large (50') 
six meter
yagi and relatively small yagis for 144, 220, 432, and 1296.  I need 
to be able 
to work on the antennas from the ground level as I cannot climb.

Any comparisions or comments would be appreciated.  I have read good 
and bad about both approaches.

Richard W5SXD
Mineral Wells, Texas

TowerTalk mailing list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>