What works easier ... aluminum foil .. `ties cheap at COSTCO and the likes
.. easy to staple, bend, etc.. hint .. don't cut at the end of runs, simply
fold over like a Christmas wrap and come back the other way, and eliminates
a possible "disconnect" at that point .. works swell in fiberglass canopies,
too .. you can glue it to the ceiling there .. rubber cement, so easily
Buy the W I D E roll .. more convenient!
First time I did this type project, used chicken wire... next time, tinfoil
... never went back to poultry electronics!
Mark Nelson - AA6DX
----- Original Message -----
From: "Jason Reber" <firstname.lastname@example.org>
Sent: Saturday, December 09, 2006 8:53 AM
Subject: [TowerTalk] Roof Counterpoise
I would like to set up a vertical antenna at my QTH, but my small
backyard is arranged such that it is impossible to set up a good radial
system. In addition, my house is right in the middle of the yard, so the
best place to put the antenna would be on my roof.
Rather than running radial wires all over my roof, I was wondering if
anyone on the list has tried making a counterpoise system by placing
wire mesh (such as rabbit wire) on the underside of the roof in the
attic? I have easy access to the underside of the roof, so the mesh
could be stapled (using short staples, of course) right to the roof
sheathing underside. The pieces of mesh would all be tied together to
create a large counterpoise.
I have not been able to find much information about the effectiveness of
such a counterpoise in the Antenna book, or from other source, so I
would welcome anyones experience or advice.
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.409 / Virus Database: 268.15.15/580 - Release Date: 12/8/2006
TowerTalk mailing list