I have a HAM 2 that I would like to take apart to insure it is OK to install in
a tower. It worked when I took it down and works now on the bench but I would
feel better about the installation if I **KNEW** it was OK inside. I would
also like to swap out the terminal strip with a new one with stainless
hardware. I have Googled it and found lots of references to the electrical
elements but no instructions on the mechanical aspect of the effort.
Does a step-by-step instruction set exist and if so does anyone have one I
might borrow or if it is commercially available where might I purchase same?
Clint - W5CPT
TowerTalk mailing list