[Top] [All Lists]

Re: [TowerTalk] Antenna/Tower Grounding (Lightning Protection)

To: <>
Subject: Re: [TowerTalk] Antenna/Tower Grounding (Lightning Protection)
From: "Al Williams" <>
Date: Fri, 5 Jan 2007 15:48:51 -0800
List-post: <>
----- Original Message ----- 
From: "K4SAV" <>
To: <>
Sent: Friday, January 05, 2007 11:23 AM
Subject: Re: [TowerTalk] Antenna/Tower Grounding (Lightning Protection)
> I was once called in to debug a
> problem on a piece of electronic hardware, and when I got to looking at
> it, the designer had run all the many grounds off each of the PC cards
> and had taken them all back over 3 feet of wire and tied them all
> together at one common point.  What a disaster that was. Another case of
> someone thinking that an SPG means only ONE ground.
> I wish I could wipe the term completely, but it is firmly engrained in
> our literature.
> Jerry, K4SAV

If your name was Hal, then the designer tying the PC card grounds back to a 
common point could have been me except that the run was less than 3 feet! 
After studying "proper grounding techniques",  I chose to do a single point 
ground for each PC card in the 19 inch assembly of cards and then each 
assembly to a rack single point ground and on to the actual ground on the 
floor. This rack was an automatic wafer IC test set and  contained about a 
thousand IC chips and about a thousand transistors so it was difficult to 
try to pinpoint the cause of the many anomalies that were occurring.

After a couple days of debugging, my technician, Hal decided to change the 
card ground wires from the single point to the nearest ground.  The 
anomalies went away and Hal went out to a free dinner!  That occurred about 
25 years ago but I still remember it very clearly.




TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>