[Top] [All Lists]

Re: [TowerTalk] Yaesu Rotor Problem

Subject: Re: [TowerTalk] Yaesu Rotor Problem
Date: Wed, 14 Mar 2007 22:57:11 EDT
List-post: <>
Getting closer, I think.  After following suggested  troubleshooting, found 
that the pot in rotor unit goes from zero (full  left), rotating right, to 
400ohms at approximately 225 degrees, then drops  immediately to ZERO for the 
45 degrees...  not good... will put a  500 ohm pot across the control unit to 
confirm that there is not also  a problem in the display unit.  Then try 
finding the replacement  pot for the rotor from Yaesu...  
Thanks, Steve 
<BR><BR><BR>**************************************<BR> AOL now offers free 
email to everyone.  Find out more about what's free from AOL at

TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>