Towertalk
[Top] [All Lists]

Re: [TowerTalk] TDR recommendations?

To: "Jim Lux" <jimlux@earthlink.net>,"rf@xemaps.com" <rf@xemaps.com>,"towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] TDR recommendations?
From: "Rob" <VE6TR@telus.net>
Date: Sun, 18 Mar 2007 08:24:47 -0700
List-post: <mailto:towertalk@contesting.com>
Greetings,

Suggest an HP 3586 level meter.  You can cut lines to within a 1/4 of an inch 
for phasing 
accuracy.  

.. 73  Rob VE6TR


On Sat, 17 Mar 2007 21:19:08 -0700, Jim Lux wrote:

>At 08:11 PM 3/17/2007, Howard Klein wrote:
>>I'm looking for recomendations for least expensive but dependable TDR's
>>usable for antenna phasing. Any comments on the  Riser Bond 1205CXA or
>>Tecktronix 1503 both of which are available on Ebay in the $500 range or
>>other suggestions.
>>Howard..K2HK
>
>
>For phasing?
>So, say you want 10 degree accuracy at 30 MHz.. that's a time delay 
>of 33 ns/36 or about 1 ns precision.
>
>Might be easier to use an antenna analyzer, short the end of the 
>coax, and look for the dips.  A lot more precision at the expense of 
>a bit more time.
>
>Any sort of CW measurement (i.e. antenna analyzer, impedance bridge, 
>etc.) is going to have a much better SNR than a pulsed measurement, 
>and the inherent precision of the measurement will be better.
>
>A TDR is real nice if you're looking for bumps in the response from 
>bad connectors or crimps in the dielectric, and even then, these 
>days, a good vector impedance bridge and some software to turn the 
>frequency sweep into time domain would probably be a better way to do it. 
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>