[Top] [All Lists]

Re: [TowerTalk] Rohn 45 Unique Installation

To: <>, <>
Subject: Re: [TowerTalk] Rohn 45 Unique Installation
From: "jeremy-ca" <>
Date: Fri, 18 May 2007 13:16:07 -0400
List-post: <>
You can always sink a steel I or H beam or even a telephone pole and attach 
the guy up at a higher level.
I sold and installed a 150' 45G across the street for a neighbors commercial 
repeater site; his property is only 90' wide. All 3 guys go to elevated H 
beams and havent budged in 18 years with 10-12 20' collinears and a few 
point to point VHF yagis on it.

Former Rohn Dealer

----- Original Message ----- 
From: <>
To: <>
Sent: Friday, May 18, 2007 11:46 AM
Subject: [TowerTalk] Rohn 45 Unique Installation

>  Time for me to ask for some advice. I have limited space to put up 60feet 
> of Rohn 45. I intend to put the first section in the ground and then a 
> house bracket heavily fortified at 23 feet. I know that only allows me to 
> do a 40 foot total height without additional brackets or guys. I would 
> like to put up the additional 20 feet, but my guy anchor locations are 
> limited. The angle of a guy to the ground would be pretty steep as I only 
> have about 20+ feet before I am into a drive way vs the 48 feet I would 
> noramly need. The other two can be much less of an angle if I tie them 
> into my roof which is at approximately 30 feet. The problem with the two 
> sides that would go to the roof is that I can not get the spread to give 
> me the 120 degree angle between the guy wires. My question is this....can 
> I put this up and feel confident it will stay there. It will be tied into 
> the house very well...just can't get all the guy wires at the normal 
> angles and the 120 degree spread.
> Looking for your advice on feasability and what are the best anchors to 
> use on the roof or in the gable ends.
> Bob WV0C
> ________________________________________________________________________
> Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading 
> spam and email virus protection.
> _______________________________________________
> _______________________________________________
> TowerTalk mailing list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>