I have one installed in my G-2800DXC and had no problems at all.
----- Original Message -----
From: "Byron Lichtenwalner" <email@example.com>
To: <BobK8IA@aol.com>; <firstname.lastname@example.org>
Sent: Saturday, September 08, 2007 9:05 PM
Subject: Re: [TowerTalk] Idiom Press RotorCard - Yaesu DXA
> I have one installed in a T2X for about 2 years now.
> Works fine when driven with a true serial card or an USB to serial port.
> Installation and operation worked fine following manuf. instructions
> Byron, W3WKR
> ----- Original Message -----
> From: <BobK8IA@aol.com>
> To: <email@example.com>
> Sent: Saturday, September 08, 2007 1:52 PM
> Subject: [TowerTalk] Idiom Press RotorCard - Yaesu DXA
>> Tower Talk folks;
>> Any of you use the Idiom Press RotorCard - Yaesu DXA, for control of a
>> G-2800DXA rotator? Product reviews on eham.net seem good, but hardly
>> giving a review is familiar to me, like a lot of the TowerTalkians are.
>> The reason I am thinking of this product is to fullly integrate my
>> (N7RQ) station into my shack, giving her a separate operating position
>> she's been used to. That card should allow her to serially tie her
>> computer to
>> the normal Yaesu control box on my desk, about 8 ft away. So the two of
>> ideally, could share a single rotator box, without either one of us
>> leaving the
>> operating position.
>> The price of this card seems very inviting, especially considering
>> 1. Looks easy to install. Comments?
>> 2. Any problems with operation? Maintenace?
>> 3. This device still allows manual operation, correct?
>> Tnx to all!
>> 73, Bob K8IA
>> ************************************** See what's new at
>> TowerTalk mailing list
> TowerTalk mailing list
TowerTalk mailing list