I would recommend calling Mike (Owner) of Msquare and discuss this with him. He
is very nice and very helpful. He is naturally very busy, but will return your
call. If it were me, I would get the controller out of the equation to start
with. Try driving it with a separate power supply. They made AC and DC versions
so you will need to know the voltage type and level. I used a variac to drive
mine when I had controller problems and it worked fine. They have limit
switches so you can't drive it beyond limits. That will tell you if you have
controller problems or not.
John Owens - N7TK
Date: Fri, 26 Oct 2007 18:58:36 -0700 (PDT)
From: Steve Jackson <firstname.lastname@example.org>
Subject: [TowerTalk] Orion rotator ... trouble?
Content-Type: text/plain; charset=us-ascii
I have the M2 Orion rotator (sorry, 'positioner') with the RC-2800P-A
unit, red LED vintage.
It's sitting in the tower on a shelf near the top of 80' of 55G. Turns an
Optibeam 16-3, a rotating 40/30 M2 dipole, and a F12 N1217 dualband WARC yagi.
Has been there for about 7 years with no troubles until today.
I find that I can't turn the antennas counterclockwise ... I try to dial in a
heading of, say, 160 degrees when I am at an indicated 197 degrees. The
(in mode 1 at speed 1) shows that it 'wants' to go there, the relay clicks,
The other way is bad, too: An attempt to go from 197 degrees clockwise to,
220 degrees DOES increment the reading - very slowly and erratically - and only
by a few degrees. Then it stops. Can't go back CCW afterwards, either.
Attempts at control via the serial port result in the same actions. The
box is not overheating, or acting oddly in any way.
DC voltage on the disconnected motor line shows about 48V DC at the box
terminals. The disconnected control line voltage is 11.6V at the box. A
resistance check of the motor leads (at the box end, and disconnected) shows
megohms, but inexplicably with a 'negative' sign when the test leads (Fluke
are reversed... odd, like it was being powered from someplace ... and there are
about 300 mV on the motor wires. That might be a clue. I haven't the foggiest
idea how one can get DC voltage off of 400' of a pair of wires that terminate
into a motor winding!
A quick walk out to the tower, 300' back in the woods in the misty rain and at
night, shows no obvious anomalies. Of course, I'll do a more thorough check in
the morning when it's light out.
TowerTalk mailing list