[Top] [All Lists]

Re: [TowerTalk] 160m Antenna Planning

To: "Richardson, Ed" <>,
Subject: Re: [TowerTalk] 160m Antenna Planning
From: Gene Smar <>
Date: Thu, 13 Dec 2007 12:15:40 -0600 (CST)
List-post: <>

     It sounds as if option two, the sloper wire, is your best bet, given the 
constraints of your installation.  In my 1/3 acre suburban lot I have a 
shunt-fed Trylon 64-footer operating on 160M and a sloper for 80M off it as 
well.  The trick with the sloper is to find the tap point for the coax shield 
on the tower that gives you the best impedance match for the band.  This might 
mean you'll have to climb your tower a couple of times to get it to work best, 
but it should work for you on 160M.  

     BTW:  I used tinned bronze connectors fromm Harger to make all the wire 
connections to my Trylon including the coax shield for my sloper.  Check them 
out at for their 222T 
connectors (I used these to connect the #2 tinned solid ground wires to the 
pre-drilled holes on the bottom tower legs) and  for their 213T clamps 
that I used on the ground wires off my coax shields, including the sloper's.

73 de
Gene Smar  AD3F

 From: "Richardson, Ed" <>
Date: 2007/12/13 Thu AM 09:39:04 CST
Subject: [TowerTalk] 160m Antenna Planning

Hello TT


In planning for the spring tower installation, I want to start planning 
something for 160m.


I live on a suburban lot of 55 x125 and the 50ft Trylon will be installed in 
the rear yard, 5 ft from the rear of the house, the rear property line is 44 
feet away. There will be a 12 foot mast with an Optibeam 5 band beam, a 2 el 
40m beam and a 6 el 6m beam for top loading. Feedlines will be grounded to the 
tower, top and bottom, At least 8 radials with ground rods spaced 16 feet apart 
will serve as lightning protection. The tower foundation will also be used as a 
UFER ground. 


I was considering shunt feeding the tower but the XYL is opposed to me taking 
up more of the real estate with a sloping wire and feed box. Also with young 
kids playing in the yard, more wires are a bad thing.


The second option I was considering is feeding a ÃÂ wave wire at the top 
running almost horizontally (85')  across the yard and then vertically (45') 
down the tree, using the tower as the other half of the antenna. I guess this 
is more of a sloper.


The third option would be the inverted L but again, this requires a vertical 
wire parallel to the tower and the XYL is opposed to the additional space this 
would require. 


Are there other options? Suggestions?




"Where everyone else is DX"



TowerTalk mailing list


TowerTalk mailing list
<Prev in Thread] Current Thread [Next in Thread>