[Top] [All Lists]

Re: [TowerTalk] Yaesu G800s Rotator

To: <>
Subject: Re: [TowerTalk] Yaesu G800s Rotator
From: "David Robbins K1TTT" <>
Date: Wed, 26 Dec 2007 21:54:29 +0000
List-post: <>
Before you open the rotor check the resistance of the indicator pot as it
rotates from end to end.  There are many more problems with Yaesu indicator
boxes than with the rotor pot itself.

David Robbins K1TTT
AR-Cluster node: 145.69MHz or telnet://

> -----Original Message-----
> From: [mailto:towertalk-
>] On Behalf Of Scott Stembaugh
> Sent: Wednesday, December 26, 2007 20:36
> To:
> Subject: [TowerTalk] Yaesu G800s Rotator
> I have acquired a Yaesu G800s that I have been told has a problem with
> showing the actual position.  The original owner knew how long it took to
> rotate and occasionally stepped outside to verify that he was pointing
> where
> he thought he should be.  I am planning on opening up the rotator to see
> if
> I can correct the problem before I put it up next spring.  While I have it
> open is there anything else I should do preventive maintenance wise?  Any
> "common" failures/problems that I should be on the lookout for?
> And if the pot, or any other parts, has failed what is a good resource for
> parts for this rotator?
> Thanks and vy 73,
> --Scott N9LJX
> --
> ------
> _______________________________________________
> _______________________________________________
> TowerTalk mailing list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>