Towertalk
[Top] [All Lists]

[TowerTalk] FWD: RE: cleaning aluminum beam elements

To: towertalk@contesting.com
Subject: [TowerTalk] FWD: RE: cleaning aluminum beam elements
From: "Doug Westacott" <ve6pr@canada.com>
Date: 16 Feb 2008 13:41:34 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>






>------- Original Message Follows -------
>From: ve6pr@canada.com
>To: "Artmouton"<k5fnq@cox.net>
>Subject: RE: [TowerTalk] cleaning aluminum beam elements
>Date: Sat, 16 Feb 2008 13:40:17
>
>
>Art
> 
>save yourself some labour, time and effort.... and achieve a better result..
> 
>I use an elecric drill fitted with a drum like brush attachment used to strip 
>paint...
> 
>I forget the actual model...but they are virtually all the same....check the 
>hardware stores...
> 
>I set the drill up in a bench vise...and run the element on the brush....
> 
>this method restores the al to a mint finish..  You will spend hours with any 
>manual method to achieve the same results as this metod does in about 3 
>minutes...
> 
>Same idea as trying to hand mix 4 yuards of concrete vice renting a cement 
>mixer..
> 
>Doug
>VE6PR
>
>
>
>
>
>
>
>>------- Original Message Follows -------
>>From: "Artmouton" <k5fnq@cox.net>
>>To: <towertalk@contesting.com>
>>Subject: [TowerTalk] cleaning aluminum beam elements
>>Date: Sat, 16 Feb 2008 11:11:14 -0600
>>
>>I am putting up a used Cushcraft A3S (with 4- meter kit) that was up for a 
>>few years (local conditions in S. Louisiana with salt air and usual crud) do 
>>that it has the usual tarnish, dirt, etc on the elements.
>>
>>Local suggested cleaning it with steel wool and soap and water.
>>
>>I intend to break each section down, clean it, open the traps, replace any 
>>bad end caps, remeasure and re-construct.
>>
>>Just wondering if there were any other suggestion from the group?
>>Art K5FNQ
>>
>>_______________________________________________
>>
>>
>>
>>_______________________________________________
>>TowerTalk mailing list
>>TowerTalk@contesting.com
>>http://lists.contesting.com/mailman/listinfo/towertalk
>
>

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] FWD: RE: cleaning aluminum beam elements, Doug Westacott <=