Les. I looked at the schematic and DO NOT WIRE OR HOOKUP TO 220 Volts. All
the control relays ect are wired in a 110 Volt setup. It's a old relay logic
circuit and would require a lot of parts and rewire changes. A lot of
weatherproof motors are duel voltage. If you have a straight run from the
circuit panel have your electrician rewire it back to a 110 Volts setup and
you are good to go. 73 Gene K2QWD
----- Original Message -----
From: "Les Kalmus" <email@example.com>
To: "TTalk" <firstname.lastname@example.org>
Sent: Monday, February 18, 2008 3:46 PM
Subject: [TowerTalk] UST MDX-589 Electrical Question
>I have an older US Tower, model MDX-589. The motor is wired for 120V.
> The motor label clearly shows it can be set for 240V.
> I have had 240V brought to the tower site. Can someone tell me if the
> raise/lower toggle switch needs rewiring for 240V?
> If so what needs to be done? I know people with MDX-589 towers which run
> at 240V but I don't know if the switching is the same.
> Les W2LK
> TowerTalk mailing list
TowerTalk mailing list