I agree with Steve. The priority is protecting the house. With arrestors
at the tower only, a surge could be induced in the portion of the cables
leading from the tower to the house, and there would be no protection
from the surge jumping right to the equipment inside the house. There's
an interesting article about that in the February issue of QST.
The arrestors should be located at the bulkhead entrance to the house.
The bulkhead panel should be bonded to the single-point ground, which in
turn should be bonded to all grounds coming into the house: AC, telco,
cable, satellite etc.
I have a set of arrestors at the bulkhead entrance, and another
identical set at the tower. One reason is that I have SO2R switching
equipment at the base of the tower and I wanted to protect it. Also, the
run to the house is over 225 feet, which is a long way for a surge to
travel before finding a path to ground. Seemed like a good idea to give
it a shorter path to protect the long and very expensive cable runs.
73, Dick WC1M
> -----Original Message-----
> From: K7LXC@aol.com [mailto:K7LXC@aol.com]
> Sent: Monday, February 25, 2008 6:25 PM
> To: email@example.com; firstname.lastname@example.org
> Subject: Re: [TowerTalk] Lightnig Arrestors at tower base or house
> In a message dated 2/25/2008 12:42:59 P.M. Pacific Standard Time,
> email@example.com writes:
> > I've seen descriptions and pictures of installations where
> arrestors were installed in a weather proof box at the tower base and
> where they are at the house entrance. Which is better?
> Well, the whole idea is to keep the transients out of the
> house so
> that's where your Single Point Ground System should be and all of the
> transient arrestors.
> Steve K7LXC
> TOWER TECH
> **************Ideas to please picky eaters. Watch video on AOL Living.
TowerTalk mailing list