In a message dated 4/19/2008 8:24:41 A.M. Central Daylight Time,
> Perhaps a naïve question, but if this is a known flaw, why hasn’t the
manufacturer corrected the design/welding problems? Has anyone informed them
about this hazard?
Jeez, it's not a hazard. The tower was designed and manufactured to
standards and specs. Don't forget that the Rohn stuff is primarily for
commercial applications where the pointy top is a good place for a VHF/UHF
The broken pointy tops were both a result of overloading. A ham
overloading a tower?!? Go figure.
**************Need a new ride? Check out the largest site for U.S. used car
listings at AOL Autos.
TowerTalk mailing list