[Top] [All Lists]

[TowerTalk] How to deal with bad fitting Rohn 45 sections?

To: "" <>
Subject: [TowerTalk] How to deal with bad fitting Rohn 45 sections?
From: Rob Frohne <>
Date: Sun, 20 Apr 2008 19:11:35 -0700
List-post: <">>
Hi Gentlemen:

Thanks to Steve's good advice, I checked the alignment of the Rohn 45
sections I have and found that some sections are out of alignment by
almost 1/4".  Some of this tower was left over from a project up in
Seattle, and I suspect that it may have been put aside as not well
fitting, but I'm not sure.  I think N2EA mentioned a while back on this
list that he had to have a section cut apart and re-welded.  I hope I
don't have to do that.  I am tempted to try and bend the ends a little
with a jack or something to make things align, especially on one section
that looks a little bent already (in the wrong direction).  What advice
do you have for me?


Rob, KL7NA  


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>