[Top] [All Lists]

Re: [TowerTalk] How about a little T2X rehab help?

To: "Scott Robbins" <>, <>
Subject: Re: [TowerTalk] How about a little T2X rehab help?
From: "Bill Gillenwater" <>
Date: Sat, 3 May 2008 12:35:17 -0400
List-post: <">>
Scott, I've replaced that part on a couple of Hygain rotors, including the
T2X. There's not an abundance of wire, but enough to do the job with no

73 Bill

----- Original Message ----- 
From: "Scott Robbins" <>
To: <>
Sent: Saturday, May 03, 2008 11:44 AM
Subject: [TowerTalk] How about a little T2X rehab help?

> I've got a T2X recently acquired used that has a terminal strip on the
> badly corroded from exposure, to the point where 4 of the 8 screws are
> frozen solid and will not budge despite WD-40, screwdrivers, and a lot of
> begging on my part :-)
> Assuming I can get the screws on each side of the terminal strip loose
(which I
> have not tried yet), is there enough slack with internal wiring to take
> screws out, pull the terminal strip up and out without actually going in
> opening up the housing of the rotator?  Or am I going to have to pull it
> I can't really tell from looking at the pics in the manual.  In any case,
> part is going to definitely need replacing...
> Thanks in advance,
> Scott W4PA
> Be a better friend, newshound, and
> know-it-all with Yahoo! Mobile.  Try it now.;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
> _______________________________________________
> _______________________________________________
> TowerTalk mailing list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>