In a message dated 7/15/2008 7:17:36 A.M. Pacific Daylight Time,
> We're taking down 70' of rohn 25g, with a foldover section @ 30'.
> The tower is presently folded over, and has had antennas and rotor
so it's in the shape of a carot, or upside down V.
> Rather than play with old, loose guy wires, I'm inclined to cut a
leg on this
thing, and pull it over. We have a clear, level fall zone, and
plenty of work
room outside of that, for human safety, when it goes.
> As I see it, the weight of the hinge section, plus three upper
sections, will exceed
the rating of a Rohn ginpole. In order to disassemble this, we have
to bring it to vertical,
and take it apart one section at a time.
Yep. It's kind of a pain but not really that difficult - especially the 25G
> This will require re-guying, as I don't trust what I see.
It should be guyed in 4 directions just below the hinge per Rohn
instructions so I'm not sure why you'd have to re-guy it unless it was
> Does anyone think that cutting one leg, and pulling on a guy isn't
the most efficient way to go?
Efficient - yes. Fast - yes.
> About the only concern is that the foldover back-boom is not in the
plane of the direction we would
drop the tower. It would strike first, and could damage the boom,
or the hinge.
You're talking about chopping it down. OF COURSE just about everything
will get damaged to some extent.
> As a variant, we MIGHT be able to get at the top section, and remove
it...which would allow the
section above the fold to go to vertical, and thus move the back-boom
away from harm.
Sure. Just be sure to put a tagline on the top section to keep it under
control on its way up.
All of your scenarios will work. Just be careful.
Cheers & GL,
**************Get the scoop on last night's hottest shows and the live music
scene in your area - Check out TourTracker.com!
TowerTalk mailing list