Jeff Stevens wrote:
>On Fri, 2008-08-01 at 11:36 -0600, Roger N0VR wrote:
>> I like the reference to the goop-lined heat shrink. I've never heard of
>> that. Anyone have a favorite source for that stuff?
>I've used several boxes of Tech Tron branded adhesive lined heat shrink
>tubing. I buy it from a local electronics shop but found this online:
>It's advertised as the "Dual Wall Heat Shrink Kit". In their
>description, they leave out the 6 pieced of 3/8" tubing included.
>If you do a google search, you'll come up with lots of other sources of
>adhesive lined heat shrink. Mouser carries it. Heat shrink is
>expensive enough and the adhesive lined stuff is even more so. While I
>love it, I use it only when needed.
Even through the adhesive lined tubing is expensive, it still doesn't
contain enough adhesive for many sealing tasks.
Having tried it, I have gone back to applying my own hot-melt adhesive
from a glue gun, followed by plain unlined heat-shrink tubing while the
glue is still soft. That allows the right amount of adhesive to be
applied wherever it will do the most good for sealing and reinforcement.
A couple of examples:
* Apply a thick ring of hot-melt glue where a cable enters the rear of a
connector, and then apply plain heat-shrink. The glue fills the 'step'
between the connector body and the cable, making a solid, strong and
* This is by far the cheapest way to make strong and waterproof
Y-junctions. Inject plenty of hot-melt glue into the gap between the two
cables at the top of the "Y", and let the heat-shrink squeeze out the
excess. Once again, you'll have a very a strong, solid and waterproof
The final advantage of these materials is that if you need to recover a
connector or open up a joint, they can easily be cut and peeled away
leaving a clean surface.
73 from Ian GM3SEK 'In Practice' columnist for RadCom (RSGB)
TowerTalk mailing list