First, do not use braid or anything like that. As it gets wet it will corrode
between all the strands. Even protected in heatshrink or other material water
will wick into it. I use copper strap where ever possible.
I lay 2 pieces across the base pedistal and when the tower is set onto it braze
the baseplate to the copper strap. At ground level ground rods may be driven
directly through the straps with the straps brazed to the top of the rods.
This requires 4 rods.
This is very similar to broadcast installations without the copper loop and
#8 or better copper wire should be used, but remember that this may still be a
high impedance to lightning.
If you cannot or do not want to weld or braze to your tower there are
mechanical fastening methods as well as some welding methods that can be used,
but all mechanical connections will need maintained to keep a good connection.
--- On Sun, 8/17/08, Artmouton <email@example.com> wrote:
> From: Artmouton <firstname.lastname@example.org>
> Subject: [TowerTalk] Connection Tower to ground rods
> To: email@example.com
> Date: Sunday, August 17, 2008, 2:10 PM
> I have hammered in two 8' copper ground rods.
> Will probably do two more later - they ain't cheap and
> not easy (although we
> are all dirt and gumbo mud here in South Louisiana.
> I now need to attach them to tower base.
> I have some coax type shield or some very large wire.
> Which one would be best?
> Then how to connect to ground rod - dissimilar metal
> How to connect to tower - Rohn 55G.
> Prior owner had painted it.
> I will brush off paint area at connection point but do not
> want to destroy
> the coating - so how deep and how to connect to the tower
> Tnx & 73,
> Art K5FNQ
> TowerTalk mailing list
TowerTalk mailing list