> On Wed, Aug 27, 2008 at 3:38 PM, Bill Gaines AD8P <firstname.lastname@example.org> wrote:
>> Some many months ago I either asked on this reflector or read on it
>> the particular piece of equipment some of you have used to dig a 3-1/2X
>> 3-1/2X 7-1/2 deep hole for an LM-370 tower. I am at the point I can
Probably a minority opinion here:
I have dug by hand three holes that were only 3x3 feet across and 6 or 7
ft deep. I used a short handled spade, a small pick, a bucket,
a small ladder, and a yardstick to measure 3 feet. The last
one was a virtually perfect 3x3x6; almost hated to pour concrete into
it. Exactly 2 yards did it. BTW, this was dug through waterproof
"cemented hard pan." No rocks though. The other 2 holes were dug through
ordinary clay (watered first) but with rocks.
Getting down to 7 1/2 feet may require a helper to pull the bucket
up with a rope and help with the ladder.
It can be done!
If you want to use a machine, get a well digger truck with a 4 ft
auger and make the holes a 4 ft circle. They will be very accurate.
TowerTalk mailing list