-------------- Original message ----------------------
From: "Rick Karlquist" <firstname.lastname@example.org>
> > On Wed, Aug 27, 2008 at 3:38 PM, Bill Gaines AD8P <email@example.com> wrote:
> >> Some many months ago I either asked on this reflector or read on it
> >> about
> >> the particular piece of equipment some of you have used to dig a 3-1/2X
> >> 3-1/2X 7-1/2 deep hole for an LM-370 tower. I am at the point I can
> >> actually
> Probably a minority opinion here:
> I have dug by hand three holes that were only 3x3 feet across and 6 or 7
> ft deep. I used a short handled spade, a small pick, a bucket,
> a small ladder, and a yardstick to measure 3 feet. The last
> one was a virtually perfect 3x3x6; almost hated to pour concrete into
> it. Exactly 2 yards did it. BTW, this was dug through waterproof
> "cemented hard pan." No rocks though. The other 2 holes were dug through
> ordinary clay (watered first) but with rocks.
I borrowed a buddies gas powered post hole digger.. it has a 3 foot auger,
punched holes in the area and shoveled the loose dirt out, then kept going
deeper. I was way more easier than digging by hand and honestly was not too
hard. I getting ready to plant a TX-455 and dig the hole the same way.
> Getting down to 7 1/2 feet may require a helper to pull the bucket
> up with a rope and help with the ladder.
> It can be done!
> If you want to use a machine, get a well digger truck with a 4 ft
> auger and make the holes a 4 ft circle. They will be very accurate.
> Rick N6RK
> TowerTalk mailing list
TowerTalk mailing list