----- Original Message -----
From: "Rick Karlquist" <firstname.lastname@example.org>
To: "bill rubin" <email@example.com>
Cc: <firstname.lastname@example.org>; "Bill Gaines AD8P" <email@example.com>
Sent: Wednesday, August 27, 2008 5:31 PM
Subject: Re: [TowerTalk] Digging the Hole
>> On Wed, Aug 27, 2008 at 3:38 PM, Bill Gaines AD8P <firstname.lastname@example.org> wrote:
>>> Some many months ago I either asked on this reflector or read on it
>>> the particular piece of equipment some of you have used to dig a 3-1/2X
>>> 3-1/2X 7-1/2 deep hole for an LM-370 tower. I am at the point I can
> Probably a minority opinion here:
> I have dug by hand three holes that were only 3x3 feet across and 6 or 7
> ft deep. I used a short handled spade, a small pick, a bucket,
> a small ladder, and a yardstick to measure 3 feet. The last
> one was a virtually perfect 3x3x6; almost hated to pour concrete into
> it. Exactly 2 yards did it. BTW, this was dug through waterproof
> "cemented hard pan." No rocks though. The other 2 holes were dug through
> ordinary clay (watered first) but with rocks.
> Getting down to 7 1/2 feet may require a helper to pull the bucket
> up with a rope and help with the ladder.
> It can be done!
> If you want to use a machine, get a well digger truck with a 4 ft
> auger and make the holes a 4 ft circle. They will be very accurate.
I'll second that. We have an old Telephone company line truck with an auger
on it. It'll make very quick work of most holes and I can get down 7 or 8'
Might also want to call a larger electricial contractor. They often have
the ability to set poles. That involves similar equipment without the
expense of a well rig.
> Rick N6RK
> TowerTalk mailing list
TowerTalk mailing list