Yes. The factory told me to squirt some automotive grease in between the
ring and tube. This definitely helps rotation and protects the tube from
abrasion. Also, you can grease the lower thrust bearing. It has a grease
Also make sure the tube is plumb. This is done by checking the tube and
adjusting the base bolts until the tube is plumb. The base vertical member
will not necessarily be plumb when the tube is plumb.
When the tower is setup correctly, you should be able to grab the drive
shaft with one hand and turn the tower.
The most important factor for a smoothly turning tower is to make sure the
short pipe section that connects the drive shaft to the rotor can swing
freely before you clamp it in the rotor jaws. This means you must not snug
the nut against the pipe. The pipe is supposed to act like a poor-man's
u-joint, compensating for the tube not being perfectly vertical and the lack
of a real upper bearing. The ring allows the tower to flop around in the
wind, so the pipe joint has to flex. That's why the bolt comes with an
aircraft nut, which will stay in place without being snugged.
73, Dick WC1M
> -----Original Message-----
> From: Larry Mohr [mailto:firstname.lastname@example.org]
> Sent: Friday, October 31, 2008 12:26 PM
> To: email@example.com
> Subject: [TowerTalk] Question for MA-550 Owners (or any MA-series)
> New Owner (Used tower)
> Does anyone know if it's recommended to lube (grease) the lower
> where it's held by the arms circling the mast.
> Seems like my G-1000 sometimes experiences trouble turning
> during higher winds.)
TowerTalk mailing list