Good question. I should have been more clear.
This will be for bonding several ground rods together and to the main
The tower is bonded to the tower ground rods with copper strap. My station
ground is bonded to a different ground rod right outside with copper strap.
But I need to connect the rods together and to the house safety ground. I
know strap is best, but it's going to be hard to run. So I'm wondering if
#4 bare copper wire is sufficient and o.k. to direct bury.
From: jimlux [mailto:firstname.lastname@example.org]
Sent: Sunday, November 09, 2008 12:44 PM
To: Michael Fox
Subject: Re: [TowerTalk] wire size/type for bonding ground rods
Michael Fox wrote:
> What is the appropriate wire size and type for bonding together several
> ground rods?
> I'd prefer something I can direct bury.
> Michael - N6MEF
Bonding for NEC, for lightning protection (NFPA 780) or for RF? The
rules (for the first 2) are different (there are no rules for the last)
Ground electrodes being used for what? (What's ok for "earthing" a
communications system is different than what's ok for "earthing" a AC
In general, it's going to be fairly large (AWG6-ish) copper, which can
be directly buried.
TowerTalk mailing list