I understand the difference between aTH6 and a TH7 - the later has an
extra driven element so you can get a flatter SWR across the band.
IMHO, it seems like a waste of money.
I picked up an older TH6, and cleaned it up. For a variety of reasons
I decided to upgrade to a 204, so I sold the TH6 to a friend - he
disassembled the traps, cleaned it up, and made sure it was in close
to new condition. We reset the antenna to low phone and installed it
on a 50 foot tower. Anyway - SWR is 1.2 at the band edges, and flat
in the middle on all three bands.
My point being - I am not sure what value adding an extra driven
element will add to the antenna. All rigs are quite happy to work
into a slight SWR, cable losses at HF are not a major concern unless
you have really long runs. A stock TH6 is a good performing antenna
with a good SWR curve, and I don't see the value in adding an extra
Tom - VE3CX
On Wed, Nov 12, 2008 at 8:34 AM, Bill <firstname.lastname@example.org> wrote:
> I have a not assembled TH6 antenna. I also have a copy of the TH6 that was
> disassembled after years in use. I've been looking at assembling the new
> TH6 when I read the assembly manual for the TH7.
> My question: Would it be possible to use my current parts and make a TH7?
> For example, would the traps be the same?
> I asked Hy-Gain and they thought this was going to cost $500. I'm
> skeptical. Or wondering.
> Bill, AB8SC
> No virus found in this outgoing message.
> Checked by AVG.
> Version: 7.5.549 / Virus Database: 270.9.0/1779 - Release Date: 11/10/2008
> 7:53 AM
> TowerTalk mailing list
TowerTalk mailing list