Towertalk
[Top] [All Lists]

Re: [TowerTalk] 160M dipole idea for 160/80M?

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] 160M dipole idea for 160/80M?
From: "David Thompson" <thompson@mindspring.com>
Reply-to: David Thompson <thompson@mindspring.com>
Date: Wed, 10 Dec 2008 17:35:40 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
There are numerous ways to fashion a 160/80 dipole.
Years ago Mor-gain made a half size 80 with a full size 40 down the middle 
(the 80 was wrapped around the 40).  I have two of these up as vertical 
dipoles and they work quite well.  Jim West KK7C
made a 160/80 version that was the size of a 80/75 (he called it the PM 
Dipole).  The Cobra K4SAV mentioned is a open wire fed version.  These can 
be mounted horizontal, as a dipole L. or as a sloper/vertical if you have 
something tall to mount them on.

K4TWJ published using ladder line in his CQ column several years ago as a 
half size dipole.  Van W4GIW tried this and found that you actually needed 
something like 62% to be correct.  He used this on 75 very effectively.

Simple antennas include a 300 ohm twin lead/ladder line L with the vertical 
part as long as possible and the seldom used Multee from both the W6SAI and 
ARRL Antenna books.  But beware its not very good on 80 and the 52 feet 
vertical part on 160 hits
1915 khz.  Another 6 feet vertical brings the antenna down to 1835 and low 
and behold the 80 works better. You will need a matcher with the Multee.

Good low banding.
Dave K4JRB 


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>