Is there any
> way with minimal equipment to see if an MOV is still good? The relay
> coils all appear OK, so I guess they did their job.
Pete,
If you put dc on them, with a series resistor to limit the current to about 1 ma
you will see the breakdown voltage.
I have done this many times, and used MOVs on rotor control lines, and tested a
Polyphaser rotor protector which is just MOVs across the lines and know this
will work.
If you find zero volts or no current flowing you know you have a blown MOV.
You can get huge rated MOVs from Mouser for 30-50 cents each.
Here is a sample of an approximately 30 volt MOV. Mouser part #576-V39ZA20P.
This will get you to the right page on the Mouser site.
Rick K2XT
_________________________________________________________________
Insert movie times and more without leaving Hotmail®.
http://windowslive.com/Tutorial/Hotmail/QuickAdd?ocid=TXT_TAGLM_WL_HM_Tutorial_QuickAdd_062009
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|