The spacer washers that come with the rotator are about 3/16" thick -
thicker than a
normal flat washer. I don't think it matters so much for the mast bracket.
It does matter
if you put the rotator on a rotator shelf as a single normal washer will
have the bottom
outside edge of the rotator dragging on the shelf .
73, Larry W6NWS
----- Original Message -----
From: "Jim Rhodes K0XU" <firstname.lastname@example.org>
To: "John Geiger" <email@example.com>; <firstname.lastname@example.org>
Sent: Sunday, October 04, 2009 4:43 PM
Subject: Re: [TowerTalk] TR44 mast bracket
> The manual for the CD-45 which is about the same physically says
> 1/4"-20 x 1&1/4". They say to use the same size with a spacer when
> mounting to a shelf.
> At 01:54 PM 10/4/2009, John Geiger wrote:
>>I recently picked up a TR44 rotor with the lower mast
>>bracket. However, it did not come with the hex bolts to attach the
>>mast bracket to the rotor. Does anyone know what size bolts are needed?
>>73s John AA5JG
> Jim Rhodes
> TowerTalk mailing list
TowerTalk mailing list