Towertalk
[Top] [All Lists]

Re: [TowerTalk] TowerTalk Digest, Repairing Yaesu G-800SA

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] TowerTalk Digest, Repairing Yaesu G-800SA
From: "Terrence R. Redding Ph.D." <terry@oltraining.com>
Reply-to: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Mon, 18 Jan 2010 15:27:56 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Perry, thank you for your help.

I am going to get the RC1-Y-Digital-Rotor-Control, unless someone here has
had a bad experience with them.

It appears my controller is bad.  If someone has the voltage chart for the
Yaesu controller maybe I can repair it.

Terry - W6LMJ


On 1/17/10 5:32 PM, "towertalk-request@contesting.com"
<towertalk-request@contesting.com> wrote:

> Message: 6
> Date: Sun, 17 Jan 2010 16:30:57 -0600
> From: "Perry - K4PWO" <k4pwo@comcast.net>
> Subject: Re: [TowerTalk] Repairing Yaesu G-800SA
> To: "Tower and HF antenna construction topics."
> <towertalk@contesting.com>
> Message-ID: <487DEB27194B4419815379CAD2252804@Developement>
> Content-Type: text/plain; format=flowed; charset="iso-8859-1";
> reply-type=original
> 
> You can use a 12-volt battery to apply power to the rotor motor to see if it
> moves.  The polarity controls direction so make sure the rotor isn't against
> a stop.  I've used a rechargeable drill's power pack as a test power source
> before.  A "jump starter" pack will also work.  Here are two possible
> solutions if the rotor controller is defective.
> http://www.mds-ham.com/RC1-Y-Digital-Rotor-Control.htm
> http://www.greenheronengineering.com/
> 
> 73 de Perry - K4PWO
> 
> --------------------------------------------------
> From: "Terrence R. Redding Ph.D." <terry@oltraining.com>
> Sent: Sunday, January 17, 2010 11:54 AM
> To: <towertalk@contesting.com>
> Subject: [TowerTalk] Repairing Yaesu G-800SA
> 
>> I need to trouble shoot my rotor control system.  I have a G-800SA.  Does
>> someone know the output voltages of the four wires coming from the
>> controller and can someone tell me how to test the rotor from the ground
>> so
>> I don't have to remove the rotor to do it.
>> 
>> I am assuming that I have a controller problem, and that the rotor is
>> fine.
>> Therefore, I most likely will buy a new controller, and redo the control
>> wires.  Are there aftermarket controllers to consider, or is my only
>> choice
>> to go with a replacement Yaesu controller?
>> 
>> All comments appreciated.
>> 
>> Terry


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>