Isn't the time delay pluggable? There is too much snow between me and the
tower base to want to check personally, but I would certainly hope it is
easy to change if needed.
That begs the question of why it is there.
I had assumed that the time delay was to let any 'wind down' of the
winch/motor assembly to happen before the motor tries to move things in a
different direction. Although the rate at which everything is moving seems
pretty slow I suppose there is something in the system with just enough
inertia to put a serious load on the motor when it is trying to run in a
To me the fact that your motor stalls when you change direction is indeed a
'clue'. One should allow things to stop moving before changing directions is
what it is trying to tell us and the delay relays simply enforce that when
you are raising and lowering the tower remotely from the base.
> -----Original Message-----
> From: email@example.com
> [mailto:firstname.lastname@example.org] On Behalf Of Rick Karlquist
> Sent: Saturday, February 13, 2010 7:09 PM
> To: email@example.com
> Subject: [TowerTalk] Why time delay on UST MDPL?
> The time delay relay for the up direction on my HDX5106 seems
> to have failed in such a way that there is no longer any delay.
> The motor starts cranking as soon as I switch to up.
> This brings up the question as to why there needs to be a
> delay in the first place. Does anyone know why? I noticed
> that if I am cranking up, and turn the switch to stop, and
> then immediately turn it to up, the motor stalls. If I wait
> a few seconds, it works fine. I don't know if this is any
> kind of clue. The time delay in the down direction seems to
> still work, since there are separate relays. It cranks down
> after waiting a few seconds.
> Rick N6RK
> TowerTalk mailing list
TowerTalk mailing list