How does this wind loading information apply to a bertical antenna which is
rigidly mounted at the base and flexes in the wind?
In addition, if the vertical antenna is mounted on top of a 22 ft tower,
which is anchored in concrete, how does this info apply?
22 ft tower is short in comparison and maybe can be considered non-movable
and then the vertical can be seen as the same as if it were mounted on the
"In the Beginning there was Spark Gap"
----- Original Message -----
From: "Charles Coldwell" <firstname.lastname@example.org>
To: "Tower and HF antenna construction topics." <email@example.com>
Sent: Thursday, February 18, 2010 2:55 PM
Subject: Re: [TowerTalk] wind load
On Thu, Feb 18, 2010 at 2:02 PM, Gene Smar <firstname.lastname@example.org> wrote:
> To get these figures into engineering terms, you'd have to convert the
> wind speed into pounds-per-square-foot
> http://www.arraysolutions.com/Products/windloads.htm and multiply by the
> EFFECTIVE area of the antenna. Then this force is applied to the top of
> tower; let's say the tower is 100 feet tall. In the example, the force of
> 70 mph wind is 12.54 psf. The total forced applied to the tower at 100
> AGL would be 12.54 X 15 = 188 pounds.
Well, that is substantially less than the 450 pounds I came up with
from the "30 pounds per square foot in a 70 MPH wind" rule mentioned
> The trick comes in determining what the effective area (sqft) of the
> antenna really is. Manufacturers are unclear in their literature in how
> they calculate the advertised areas of their antennas.
I suppose this is due to uncertainty in the drag coefficient since the
geometric cross-section should be unambiguous. Rewriting the Array
Solutions formula as
F = A * 0.00256 * W * W * Cd
the effective cross-section is the product A * Cd, where A is the
geometric cross-section, and Cd is 1.2 for long cylinders and 2.0 for
> That calculation showed that my D40 rotatable dipole had a spec from
> Cushcraft of 1.3 sqft, whereas the "shadow area" of the elements
> out to be 3.55 sqft. Go figure.
Yeah, I can't make up that difference no matter how I play around with
Charles M. Coldwell, W1CMC
"Turn on, log in, tune out"
Winchester, Massachusetts, New England (FN42kk)
GPG ID: 852E052F
GPG FPR: 77E5 2B51 4907 F08A 7E92 DE80 AFA9 9A8F 852E 052F
TowerTalk mailing list
TowerTalk mailing list