Gene Fuller wrote:
> What is the maximum DC voltage used successfully/recommended for one of the
> "small" PPM's ? What speed was accomplished and how was the brush life at
> that voltage ?
> I 'm building a power supply to put at the base of the tower and can change
> the voltage from about 30 to 48 volts in 6 volt steps. Cable to PPM will be
> 100 feet of 3#12's. I'm figuring about 0.5 ohms and about a ten amp demand
> i.e. a 5 volt drop.
> Any suggestions will be greatly appreciated.
> Thanks,
> Gene / W2LU
Handy to remember..
AWG 10 wire is about 0.1" in diameter and 1 ohm/1000 ft.
For every 3 gauges, the resistance doubles.
For every 10 gauges, the resistance is x10.
So.. 200 ft of AWG 10 (up and back) would be 0.2 ohms.
Going to AWG 12 is a bit less than doubling (0.4 ohms)
Your estimate of 0.5 ohms for AWG 12 is a bit pessimistic. (assuming a
single conductor up and back)
If you were thinking triple AWG 12 up and triple AWG 12 back, you'd be
much less than 0.2 ohms total, since 3 AWG12s is almost twice the cross
sectional area of a single AWG10.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
