Thanks for the comments on PPM's. They pretty much fall in line with what I
have observed over the past few decades of using them. Probably about 35 VDC
with a 200 foot loop of # 12 should give 1/2 to 1 rpm for my LP (15 ele on
46 ft boom). Perhaps a lilttle slow, but you know it's going to get there
and not stall along the way. A few decades ago I runied a good PPM by giving
it the speed modification - definitely not recommended. My feeling is that
anyone who doesn't mind spending a few bucks would get the ideal rotation
system by using one of Kurt's PPM's with a Green Heron controller. All you
would want of torque, breaking, long term reliability and convenience.
Gene / W2LU
----- Original Message -----
From: "Gene Fuller" <email@example.com>
Sent: Sunday, March 14, 2010 10:58 PM
Subject: [TowerTalk] Prop Pitch Motor
> What is the maximum DC voltage used successfully/recommended for one of
> the "small" PPM's ? What speed was accomplished and how was the brush
> life at that voltage ?
> I 'm building a power supply to put at the base of the tower and can
> change the voltage from about 30 to 48 volts in 6 volt steps. Cable to PPM
> will be 100 feet of 3-#12's. I'm figuring about 0.5 ohms and about a ten
> amp demand i.e. a 5 volt drop.
> Any suggestions will be greatly appreciated.
> Gene / W2LU
> TowerTalk mailing list
TowerTalk mailing list