I use the same Polyphaser and my MJF-259B works just fine through it.
73, Glenn/KD0Q
----- Original Message -----
From: "w4lde" <w4lde@numail.org>
To: "TowerTalk" <towertalk@contesting.com>
Sent: Tuesday, March 16, 2010 11:53 AM
Subject: [TowerTalk] Polyphaser
>I am installing new coax from the tower to the shack and have inserted a
> polyphaser IS-50NX-CO, N-style connector and wanted to check everything
> out from the shack to the tower before I connect it to the beam. The
> polyphaser is located at an entrance panel some 30' from the shack.
>
> The unit is not new but did come in the original box with all hardware
> and instructions, however, how do I check out the unit to know if its
> still good?
>
> This is a DC blocking style so there's no connection between center
> pins, I have a MFJ antenna analyzer but I don't think it sees past the
> polyphaser fro the shack end.
>
> How does one know if the unit is OK or not? There is a varied opinion
> as to there worth and maybe I should select a different product. I
> always disconnect the antennas in the shack but wanted to add some
> protection at the building entrance plus I can also disconnect the coax
> and also the rotor cables there.
>
> 73 de
> Ron W4LDE
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|