Looks like the bolts are 1 1/2" long and either a 1/4" or 3/16" and my
guess is a 3/16" I believe its 20 threads per inch. There is no
markings on the bolt and a standard 1/2" socket fits a little loose and
not a snug as I expected, so I wonder if its metric? Probably made in
On 3/20/2010 12:39 PM, Dick Green WC1M wrote:
> What are the dimensions of the bolts -- length, diameter and threads per
> inch? Also what is the depth of the holes? I can measure the bolts and holes
> on a T2X I have on the ground and let you know how they compare.
> 73, Dick WC1M
>> -----Original Message-----
>> From: w4lde [mailto:email@example.com]
>> Sent: Saturday, March 20, 2010 11:02 AM
>> To: TowerTalk
>> Subject: [TowerTalk] Trouble mounting T-2X
>> Started to mount a new T-2X purchased on 3/3/10 yesterday. Made up all
>> of the plugs and checked the rotor out on the ground at the tower.
>> Rotor worked properly on the ground
>> Dropped the tower and tilted it over so we could install the rotor body
>> and mast. We checked the bolts and the tower mounting plate for the
>> correct mounting and they aligned OK. The rotor plate is heavy duty 3/8
>> to 1/2" thick and welded in place.
>> I had only insert the mounting bolts in the body a few turns before
>> taking it outside and didn't notice anything unusual. Used some anti
>> seize lube' on the bolts.
>> My helper (brother) did notice that the rotor body bolt holes seemed a
>> little out of the pattern and very close to one edge, however, when
>> aligning the body to the rotor plate they look almost dead on. So we
>> proceeded, then the trouble started.
>> The mounting bolts turned in hand tight about a 1/4 of the way in, not
>> free at all and got to the point (1/4 way) that we decided to use my
>> small ratchet set.
>> Not even 1/2 way in the bolts started to seize and we were very
>> reluctant to proceed. I checked the depth of the holes in the body and
>> they are free in equal to the length of the bolts.
>> We backed out the bolts and lowered the rotor to the ground and again
>> tired to insert and screw in the bolts while free of any mounting plate
>> with the same results. It almost seems like the threads are not right
>> for the mounting bolts or the bolts are two long but we didn't want to
>> over tighten. The bolts were in a plastic package so I assume they were
>> the correct ones supplied by the factory.
>> Looks like we did slightly bend one bolt head and not sure when that
>> occurred but I can always get a new bolt locally.
>> Any ideas? Your input and help will be appreciated.
>> 73 de
>> Ron W4LDE
> TowerTalk mailing list
TowerTalk mailing list