You are not confused -- I am. I pulled the wrong plot from the file and did
not read the title, just the frequency.
This is the scan that I should have put up to begin with. The scan only
shows the impedance at the entry point to my station. I am not sure about
the pattern. The input impedance on 18.6 MHz looks OK but not super.
> -----Original Message-----
> From: firstname.lastname@example.org
> [mailto:email@example.com] On Behalf Of David Thompson
> Sent: Monday, April 12, 2010 4:10 PM
> To: Tower and HF antenna construction topics.
> Subject: Re: [TowerTalk] XM-240 question
> I am confused Tod. This is labeled KT-34XA not XM-240.
> I use the older 2 el Cushcraft on 17 (353 DXCC SSB). I tried
> it on 12 as Bill K1MM used his there and found it had too
> much of a cloverleaf pattern although I could work stations.
> I finally put up a W9PNE version of the G4ZU X beam. I have
> 319 DXCC SSB there since the band opened but with several
> lapses without any antenna. I sure needeed YI9PSE but no
> propagation except to T32 and H44MS (the wrong way HI).
> 73 Dave K4JRB
> DXAC SE Division
TowerTalk mailing list