Yes Never-Seez does work. I have used it for years.
----- Original Message -----
From: "Kurt Cathcart, KR2C" <Kurt@KuhlRoad.net>
To: "Tower and HF antenna construction topics." <firstname.lastname@example.org>
Sent: Tuesday, April 13, 2010 9:14 AM
Subject: Re: [TowerTalk] dxengineering U-bolts froze??
> Have this happen all the time with stainless parts. There are antiseize
> products on the market that might help.
> I've actually had them seize up so tight that I twisted the u-bolt like a
> pretzel and it broke off at the twist.
> I'm am strong like the bull, no? Well maybe I just smell like one. :)
> ----- Original Message -----
> From: "Bob AD5VJ" <email@example.com>
> To: <firstname.lastname@example.org>
> Sent: Tuesday, April 13, 2010 8:37 AM
> Subject: [TowerTalk] dxengineering U-bolts froze??
>>I like dxengineering parts; however, I installed my new th6dx this last
>> weekend with the help of the Azle Ham Club here locally. After taking
>> my Hornet Tribander I was disassembling the Hornet from the mounting
>> that I bought from dxengineering.
>> I bought it with the recommended stainless steel U-bolt clamps they sell
>> when I put the Hornet up. It was up less than a year on the tower. While
>> was loosening a couple of the U-bolt from the mast, the nut holding a
>> of the U-bolts became very hard to take off until I had to place the
>> assembly in a vice to get enough torque on my wrench to finally get the
>> off along with using a spray lubricant.
>> The threads are ruined on the nut and the U-bolt since it seemed to cross
>> thread as it came loose for no apparent reason.
>> I would have hated to have been trying this on top of the tower hanging
>> a strap trying to get it apart.
>> Has anyone else had a problem like this, I remember it wasn't hard to
>> tighten when I assembled it as it went on very easily, just taking it off
>> was very difficult.
>> Bob AD5VJ
>> TowerTalk mailing list
> TowerTalk mailing list
TowerTalk mailing list