[Top] [All Lists]

Re: [TowerTalk] Installing Rohn Preformed Big Grips

Subject: Re: [TowerTalk] Installing Rohn Preformed Big Grips
Date: Thu, 1 Jul 2010 19:47:22 EDT
List-post: <">>
Easier than riding a bicycle; just wind them onto the guy wire with a few  
inches of guy wire hanging out at the thimble/grip loop. If you leave too 
much  guy wire hanging out, trim it with small bolt cutters.
If you put them on about 3/4 of the way, you can easily unwind and  
reposition. Otherwise, you probably will destroy them when trying to remove  
Gerald K5GW
In a message dated 7/1/2010 6:40:31 P.M. Central Daylight Time, writes:

I am  about to start assembling my Rohn 45 lower guy wires. I am using 3/16 
ehs  cable 5/16 thimbles, 502 insulators and BG-2142 big grips. Are there 
instructions on how to install the big grips. I received no documentation  
with them and haven't found much on the web yet.

73 Mark N1UK  


TowerTalk  mailing  list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>