Dave et al:
I did the same thing as you did with the coax and connectors at my
single point ground bar at the shack end of the coax runs. The issue I have
with installing PL-259's or whatever simply to make coax shield connections
to ground on a tower is this is an unnecessary break in the coax. It adds
to the coax system another two connectors that could fail. And replacing
these connectors while on the tower are a PITA. If you choose the
shield-only connection, the coax remains intact. You simply must provide
adequate sealant and/or tape.
FWIW.
73 de
Gene Smar AD3F
----- Original Message -----
From: "David Gilbert" <xdavid@cis-broadband.com>
To: <towertalk@contesting.com>
Sent: Saturday, July 31, 2010 11:54 AM
Subject: Re: [TowerTalk] Grounding control line shields at tower base
>
> Even simpler and more convenient, in my opinion, is to use barrel
> connectors through a grounded bracket. I have one at both the top and
> bottom of my tower.
>
> http://ab7e.com/AB7E_Antenna_Page_4.html (bottom picture)
>
> 73,
> Dave AB7E
>
>
> Joe and I posted this
> http://lists.contesting.com/archives//html/Towertalk/2007-10/msg00356.html
> a
> while back about how we made our own coax shield connectors for just this
> purpose. The expense is low enough that there ought to be no reason not
> to
> do it.
>
>
> 73 de
> Gene Smar AD3F
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|