Why don't you put a 2 antenna switch box near the top of the tower and run
one coax down and to the shack. You can even put the DC down the coax to
switch the relay box if you don't want to run a DC line to the shack. I am
putting one of these at the top of my tower to switch between the HF beam
and a 6m beam.
----- Original Message -----
From: "Its from Onion" <email@example.com>
Sent: Friday, 13 August, 2010 7:00 PM
Subject: [TowerTalk] OTQ -
> Hey guys, I know this is a bit off topic but your learned thoughts please.
> Rohn 25 50 feet high with house bracket at 28 feet
> M2 40m 3 element survivor beam twisted with a Ham IV
> DOM mast 18 feet tall with rotor at bottom of A3 top section leaving 9 ft
> on top
> BTW- it works people so please no comments about 'next big wind' as I've
> already had them
> and Rohn towers are FAR STRONGER than you think.
> Add a Mosley CL-33 on top of M2
> The antennas react to the frequencies sent them. If you send a 10m signal
> to the Mosley
> you get zip out of the 15 an 20m parts.
> With that in mind, what would happen if you directly connected the 40 and
> the 10-15-20
> antenna together on one coax?
> My thought is that the 'antenna system' would only react to the
> frequencies feed it.
> Yet I'm sure that is to simplistic of reasoning.
> So, run 2 coax's 125 feet back to shack and switch them there?
> Thanks everybody in advance!
> TowerTalk mailing list
TowerTalk mailing list