This brings up an issue I hope to work on soon...
I will be running about 6 feedlines under my floor and up to my shack.
There will likely be two runs of LDF4 and probably 4 runs of RG8. The
SPG will be just outside the house, before the lines go under the floor.
I haven't decided yet best / neatest method of passing the lines through
the floor. I've considered cutting a 4x12 rectangular opening in the
floor about the same size as a heat duct, or something similar. Just
thought I would ask, "how do you do it?"
You can't fix stupid, but you can vote it out!
Amateur Radio Emergency Service, Clark County Indiana. EM78el
K9ZF /R no budget Rover ***QRP-l #1269 Check out the Rover Resource Page at:
<http://www.qsl.net/n9rla> List Administrator for: InHam+grid-loc+ham-books
Ask me how to join the Indiana Ham Mailing list!
On 10/21/2010 9:06 AM, email@example.com wrote:
> I'm willing to bet that the great majority of hams use an aluminum
> plate for SPG. Mine is 1/4" thick and replaces the foundation 'vent'
> under my shack window.
TowerTalk mailing list