[Top] [All Lists]

Re: [TowerTalk] Bringing feedlines through the floor

To: <>, "Dan Evans" <>
Subject: Re: [TowerTalk] Bringing feedlines through the floor
From: "Mark Robinson" <>
Date: Fri, 22 Oct 2010 00:19:43 -0400
List-post: <">>
I just put a little snip in the carpet and drilled a hole through the wooden 
floor and pushed the coax and PL259 through the hole. In fact I have several 
holes through the floor of the shack into the crawl space below.

Mark N1UK

----- Original Message ----- 
From: <>
To: "Dan Evans" <>
Cc: <>
Sent: Thursday, 21 October, 2010 10:50 PM
Subject: Re: [TowerTalk] Bringing feedlines through the floor

>I lifted one edge of a real heating duct, then, with some prying,
> moved one side of the duct away from the opening and ran all the coax
> and control lines through the new opening which is below the floor
> level.
> Soon will need to run one ladder-line through that opening and not
> sure how well I can insulate it from the metal of the duct.
> Keep tuned.
> 73
> Don
> N8DE
> Quoting Dan Evans <>:
>>   This brings up an issue I hope to work on soon...
>> I will be running about 6 feedlines under my floor and up to my shack.
>> There will likely be two runs of LDF4 and probably 4 runs of RG8.  The
>> SPG will be just outside the house, before the lines go under the floor.
>> I haven't decided yet best / neatest method of passing the lines through
>> the floor.   I've considered cutting a 4x12 rectangular opening in the
>> floor about the same size as a heat duct, or something similar.   Just
>> thought I would ask, "how do you do it?"
>> 73
>> Dan
>> --
>> You can't fix stupid, but you can vote it out!
>> Amateur Radio Emergency Service, Clark County Indiana. EM78el
>> K9ZF /R no budget Rover ***QRP-l #1269 Check out the Rover Resource Page 
>> at:
>> <>  List Administrator for: 
>> InHam+grid-loc+ham-books
>> Ask me how to join the Indiana Ham Mailing list!
>> On 10/21/2010 9:06 AM, wrote:
>>> Ditto.
>>> I'm willing to bet that the great majority of hams use an aluminum
>>> plate for SPG.  Mine is 1/4" thick and replaces the foundation 'vent'
>>> under my shack window.
>>> 73
>>> Don
>>> N8DE
>> _______________________________________________


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>