Are you sure it's the controller and not the power supply
("brick")? The original controller had similar reports -
usually tracked down to the 33V ("high power") switching
I'd suggest checking with Mike or John Mertel at SteppIR
about a replacement power supply.
... Joe, W4TV
On 3/9/2011 5:43 PM, Jim Brown wrote:
> I've been chasing a very strong, very elusive set of drifting birdies.
> They were strongest on 12M, but also were present on 15M and 10M.
> Nothing affected them until I unplugged the power supply for the SDA100,
> at which time they went away, and the overall noise on the band dropped
> by at least 10dB. This crap radiates into every antenna I've got.
> I've managed to attenuate this crap by at least 20 dB using chokes on
> the cable that runs to the antenna, the rotor cable, and both the 120VAC
> and 33VDC cables from the power supply.
> If you've got an SDA100 (that's the newer, higher voltage controller),
> you might want to check this. 15dB is a LOT! The best way to see
> what's going on is with a panadapter set pretty wide so that you see
> birdies drifting slowly up and down. I'm using a P3.
> 73, Jim K9YC
> TowerTalk mailing list
TowerTalk mailing list