Towertalk
[Top] [All Lists]

Re: [TowerTalk] Which crimper die for which connector

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Which crimper die for which connector
From: Les Kalmus <w2lk@bk-lk.com>
Reply-to: w2lk@bk-lk.com
Date: Tue, 07 Jun 2011 08:58:17 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Pete,

Try this page too: 
http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40 
<http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40>
Go about 2/3 down the page.

73, Les W2LK

On 6/7/2011 7:45 AM, Pete Smith wrote:
> I bought a crimping tool at Dayton with two dies, but the openings in
> the dies are identified only by dimensions, not by the connector they
> are to be used on.  I've tried Googling without success, but suspect
> there must be a table somewhere that I can use for reference - any ideas?
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>