I too would appreciate a copy,
Thanks, Dick, W1KSZ
On Tue, Jun 7, 2011 at 5:58 AM, Les Kalmus <firstname.lastname@example.org> wrote:
> Try this page too:
> Go about 2/3 down the page.
> 73, Les W2LK
> On 6/7/2011 7:45 AM, Pete Smith wrote:
>> I bought a crimping tool at Dayton with two dies, but the openings in
>> the dies are identified only by dimensions, not by the connector they
>> are to be used on. I've tried Googling without success, but suspect
>> there must be a table somewhere that I can use for reference - any ideas?
> TowerTalk mailing list
TowerTalk mailing list